View Full Version : designer intelli-sense
mhoover
18th January 2010, 09:19
When I change the name of a widget in designer, only the old name shows up in the intellisense, but it will compile if I try to put in the new name.
Any tips?
high_flyer
18th January 2010, 11:38
You mean the MSVC intellisense?
nikhilqt
18th January 2010, 11:39
some times in VS, it needs to recompile its intelli-sense database(.ncb) file. takes little time refresh. If you are not getting the new one. close the solution file, delete the .ncb of that project and re-open the solution again then you will find the changes you made.
high_flyer
18th January 2010, 12:39
some times in VS, it needs to recompile its intelli-sense database(.ncb) file. takes little time refresh. If you are not getting the new one. close the solution file, delete the .ncb of that project and re-open the solution again then you will find the changes you made.
In other words, intellisense is crap.
squidge
18th January 2010, 13:25
Agreed. At work I use Visual Assist - much better replacement, but it is expensive at $250. It used to be much cheaper - about $100 I think. If your a hobbyist, it's better to use QtCreator.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.