View Full Version : gdb doubt for Qt programing
arjunasd
25th July 2007, 05:50
Hi
I want to debug my Qt code using GDB. I want to set breakpoints in the code.
When I googled i found the following command : break filename:functionName. But it does not work. So how should I use this command.
Kindly help with your suggestions.
Thanks
Arjun
Is the application compiled in debug (-g) mode?
Try:
qmake -config debug
and rebuild the app.
arjunasd
25th July 2007, 16:55
Yes. I did that but still it does not pick up the functions.
Setting breakpoints using filename:line number works but not filename:function name.
Kindly help me with suggestions if possible.
Thanks
Arjun
KaptainKarl
25th July 2007, 18:46
This may seem like a bit of overkill, but consider downloading and installing QDevelop (www.qdevelop.org). It is a nice, easy to use IDE that provides debugging through gdb right in the GUI.
Karl
markcole
25th July 2007, 19:15
This may seem like a bit of overkill, but consider downloading and installing QDevelop (www.qdevelop.org). It is a nice, easy to use IDE that provides debugging through gdb right in the GUI.
Karl
I use this daily for writing and debugging. Works great. It has a gdb commandline where you can enter gdb specific commands or just use the IDE debug buttons.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.