If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to Qt Centre.

Qt Centre is a community site devoted to programming in C++ using the Qt framework. Over 90 percent of questions asked here gets answered. If you are looking for information about Qt related issue — register and post your question.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Results 1 to 6 of 6

Thread: How to step inside(debug) webkit code?

30th December 2009, 08:50 #2
yogeshgokul

View Profile

View Forum Posts

View Articles

Advanced user
Join Date

Dec 2007

Posts

628

Qt products

Platforms

Thanks

3

Thanked 89 Times in 87 Posts
Re: How to step inside(debug) webkit code?

Building the QtWebKit module with debugging symbols is problematic on many platforms due to the size of the WebKit engine. Its recommended building the module only in release mode for embedded platforms. Currently QtWebKit will always be compiled without debugging symbols when using gcc. Take a look at the last lines of src/3rdparty/webkit/WebCore/WebCore.pro if you need to change this.
More info here.

Reply With Quote
The following user says thank you to yogeshgokul for this useful post:

nish (30th December 2009)